Update : 2017.7.21 Fri 17:07
Display Plus
Solar/PVEnglish
CalLab PV modules increases measurement precision to record 1.3 percent
Display Plus  |  editor@displayplus.net
폰트키우기 폰트줄이기 프린트하기 메일보내기 신고하기
2017.04.18  08:38:30
트위터 페이스북 네이버 구글 msn
   

Germany - The calibration laboratory at the Fraunhofer Institute for Solar Energy Systems ISE (ise.fraunhofer.de)  has achieved a best value: Photovoltaic modules can now be calibrated with an even higher measurement precision of 1.3 percent. Repeatability lies at 0.4 percent. Measurement precision is a decisive factor for quality assurance in the module production and for investments in PV plants. For a volume of 10 MW, for example, each percentage point increase in measurement precision corresponds to a monetary value of about 60,000 euros.

“Maximum measurement precision is not just an academic exercise, rather it greatly helps gain the confidence of investors,” says Dr. Harry Wirth, division director of Photovoltaic Modules, Systems and Reliability. Module manufacturers have to maintain their quality assurance at a high level daily and guarantee their sold output. Power plant operators must know the module power as exact as possible in order to minimize yield uncertainty. Researchers need exact measured values to evaluate innovative technologies or to detect degradation at an early stage. All of these actors profit from low tolerance measurement of modules.

“We regularly carry out round robin tests with the world’s best accredited calibration laboratories. Germany’s national accreditation body DAkks has checked our measurement uncertainty analysis and verified the 1.3 percent,” explains Frank Neuberger, group leader of CalLab PV Modules. This backs up the very good standing that Fraunhofer ISE holds in measurement precision worldwide. Carefull tracing of the current-voltage curves as well as spectral corrections were the focus of the researchers’ optimizations.  

The calibration laboratory for PV modules at Fraunhofer ISE has the particular advantage of being able to combine highest precision with the capability of measuring large batches quickly. On the one hand, customers can be assured that their data is handled with the utmost confidentiality. On the other hand, they also profit from the research environment and the newest research results of the institute. CalLab PV Modules is the only calibration laboratory worldwide that is equipped to measure bifacial modules on both sides simultaneously with the highest precision. A new test stand has been specially developed for this purpose. This new variant of solar electricity production uses solar energy incident on the front and rear side of the module.

Copyright © Display Plus. All rights reserved.
폰트키우기 폰트줄이기 프린트하기 메일보내기 신고하기
트위터 페이스북 네이버 구글 msn
뒤로가기 위로가기

 

Main Media Kit AD Rate Print Issues Show Daily Privacy Policy Juvenile protection Contact Us
USA: 24 Happy Valley Road, Pleasanton, CA 94588, USA (tel: +1-925-989-1144)
Korea: 10F, Jaram Building, 78 Mapo-daero, Mapo-gu, Seoul, Korea (tel: +82-2-3473-6369) 청소년보호책임자 : 김홍덕
Copyright © 2011 Display Plus. All rights reserved. mail to webmaster@displayplus.net